www.changlin.com.cn in the absolute full run position. Turn the large hex nut on the end of the plunger to make adjustments and secure in place with lock nut. Fuel Injection Pump Replacement Remove the governor oil line. Removing Part No. 3824591 Engine Barring Gear Locate TDC for cylinder number 1. Push the timing pin into the hole in the camshaft gear while slowly rotating the crankshaft. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 1/2 inch ratchet or breaker bar. Caution: be sure to disengage the timing pin after locating TDC to prevent damage to the timing pin. 22 mm (PES. A Pump), 27 mm (PES.
MW Pump), 30 mm (PES. P Pump) Remove the gear cover access cap. Remove the nut and washer from the fuel injection pump shaft. 110 / 149 pages 0 mm, 16 mm djust the solenoid linkage as necessary so that the lunger is magnetically held in with the shutoff lever reparatory Steps: Clean debris. Remove all fuel lines. Remove control linkage. Remove fuel shutoff solenoid. Remove the AFC air line.