3. Disassembly and Reassembly of Major Components 3.1. Engine Disassembly z Engine part’s disassembly procedures are as follows; z For the various tool storage before disassembly and parts storage after disassembly, the shelf for parts is prepared. z At the time of disassembly and reassembly, do the work with the naked and clean hand, and also the working place must be maintained clean. z The torn parts after disassembly must be kept not to collide each other. z In disassembling, torn parts should be laid in disassembled order. 3.1.1. Oil level gauge z Take out the oil level gauge 3.1.2.
Engine oil z Remove an oil drain cock from the oil pan, and let engine oil discharge into the prepared vessel. 3.1.3. Cooling water z Remove the cooling water drain plug from the cylinder block and oil cooler, various pipes, etc. and let the cooling water discharge into the prepared vessel. 3.1.4. Cooling fan z Remove fan fixing bolts, then take off the cooling fan. 3.1.5. V-belt z Loosen the V-belt tension adjusting bolts, and remove the V-belt. Engine Disassembly - 52 - EPM2001I EFM2