3.2.5. Camshaft 1) Axial end play z Push the camshaft toward the pulley side. z Place a dial gauge onto the camshaft gear. EPM2016S z Measure the camshaft's axial end play, moving the camshaft gear by means of a driver. z If excessive end play, assemble it by means of other thrust washer. EPM2017S 2) Inspection and measurement z Visual check scratches by means of an oil stone grinding and if severe, replace it. With inspecting the cam surface for any damage with naked eyes and correct any minor z Cam lobe height Use a micrometer to measure the cam lobe height and journal diameter. If the measured number is less than the specified limit, the camshaft must replaced.
D A EA0M4062 Inspection - 70 - Limit 0.2 ~ 0.9 mm Items Standard Limit Cam lobe height (C) Intake 56.37 mm 55.17 mm Exhaust 56.43 mm 55.11 mm Cam journal diameter (A,B) 69.91 ~ 69.94 mm - C A III III B B