z Inspect the disassembled parts if there is any damage, replace it. z Assembling can be done in the reverse order of disassembling. z After assembling the nozzle, set it in the injection pressure measuring tester. z By manipulating the tester handle, inspect the injection pressure and atomizing state. EFM2056I z In case of low or high injection pressure, adjust by adding or reducing the spring tension adjusting shims. z In case that atomizing state is not good, it should be replaced. EFM2057I Inspection - 80 - New nozzle holder 300 + 8 kg/cm2 Used nozzle holder 285 + 8 kg/cm2