3.3.27. Cooling water pump z Attach the gasket of the fresh water z Assemble the fresh water pump by pump. (at cylinder block side) tightening the fixing bolts. (zigzag method) z Insert the thermostat of fresh water z Insert the O-ring to the thermostat and pump. assemble the cooling water pipes by EFM2081I tightening the fixing bolts. 3.3.28. Intake manifold z Attach the new gasket to the cylinder head side. z Assemble the intake manifold by tightening the fixing bolts. z Attach the gasket to the inlet flange and assemble by tightening the fixing bolts. z Assemble both sides by the above z Attach the gasket to the equalizing pipe method.
EFM2082I that connects the intake manifolds of both sides and assemble both manifolds by tightening the fixing bolts. 3.3.29. Exhaust manifold z Connect the exhaust manifold that is consists of two sets after inserting the exhaust gas ring between them. z Attach a new gasket to the exhaust manifold. z Attach a gasket to the exhaust elbow that Is connected to the exhaust manifold, and assemble the elbow by tighten the nuts for connection. EPM2026I z Assemble both sides in the same method as above. Engine Reassembly - 95 -