Radio / Cassette Player - Section 70 OM7004 4/05 Page 70-2 SETTING THE TIME 1. Turn the key switch ON. When in satellite mode, press and release either the 2. Press and hold DSPL/TM SET (9, Figure 70-1) for two seconds. When the number display flashes, time set mode is active. TUNE or the SEEK buttons to navigate to the next channel. Pressing and holding either of the two buttons for more than 0.5 seconds will increase the cycle speed through the channels. The increase cycle speed is approximately 10 channels per sec- ond. 3. Press TUNE / SEEK (7 & 8) to change the hour setting. 4. Press the DSPL/TM button to switch to minutes. The minute digits will flash when in this mode. 5.
Press TUNE / SEEK to change the minute setting. SEEK Mode Hold either the TUNE or SEEK buttons for more than 0.5 seconds to enter the seek mode. SEEK will appear on the display when this mode is activated. In this mode, the radio will scroll through stations and stop on the next station with a strong signal. After five seconds of inactivity, the display will return to the default mode. The clock will now display the correct time of day. OPERATING THE RADIO NOTE: If the receiver can not find a strong enough signal after two band cycles, the seek mode will discontinue and the receiver will return to the initial starting point.
BAND Press BAND (2, Figure 70-1) to switch between FM1, FM2, AM, and WX Weather (US) and Satellite (XM1, XM2 or SR1, SR2). If a separate satellite receiver is not connected to your radio and operational, the sat- ellite bands will not appear in the display. When in satellite mode, press TUNE or SEEK to navigate through the channels. Pressing and holding either of the two buttons for more than two seconds will increase the cycle speed through the channels. The increase cycle speed is approximately 10 chan- nels per second. TUNE/SEEK TUNE (7) / SEEK (8) allows you to move up or down in frequency to other stations.
There are two modes of operation for finding other stations, manual tuning and seek mode. SCAN Press SCAN button (10) to scan all stations on the current band. When a strong frequency is found, the receiver will pause on that station for about five sec- onds and then continue scanning. Scan will appear on the display along with the frequency when this mode is active. To stop scanning, press the SCAN button again. Press and hold both TUNE (8) and BAND (2) for two seconds to toggle between the two modes. The display will read either MANUAL or SEEK to indicate the mode the receiver is in.
Manual Tuning AUTO Press TUNE (8) to tune to the next higher fre- AUTO (12) allows the receiver to store the six stron- gest stations onto push-buttons 1 through 6. Press AUTO until AUTO and AS appear on the display. The presets on the current band only will now be pro- grammed with the six strongest frequencies. Presets on the other inactive bands will not be changed. Pressing AUTO again will delete the stations and default to the original preset stations. quency. Press SEEK (7) to tune to the next lower frequency. Holding either of the buttons for more than 0.5 seconds will activate fast tuning for increased speed. NOTE: The AUTO function is not functional on the satellite band.