OPERATION 2.7 Indication of fluid levels 2.8 Operating status display Operation_Pic_number:1 Operation_Pic_number:1 Fig.8 Fig.9 Text-module A = Fuel supply B = Engine temperature When the bar indicators reach the red zone, relieve the engine of load imme- diately and allow to cool down for about 2 minutes at 1000 rpm, then turn the en- gine off. C = Compressed air supply D = On-board electrical system voltage E = Hydraulic oil supply Text-module A = Wheel slip in %; (only if optional radar sensor is equip- ped). B = Tractor speed in km/h. Text-module On tractors with the optional radar sensor, use these keys to change to: theoretical speed measurement calculated from transmission speed.
actual speed based on signal from radar sensor, symbol (C) is lit. Theoretical speed calculation is activated auto- matically when tractor speed is over 15 km/h, the wheel slip indicator (A) and symbol (C) then go out. NOTE: For a precise reading, adjust the speed indi- cator under operating conditions (see also OPERATION Section 26.2). Text-module D = Driving mode indicator the selected driving mode is indicated by a spot (D). E = Rpm indicator can be changed with the buttons to: Text-module engine speed symbol (H) is displayed. rear PTO speed symbol (F) is displayed. front PTO speed symbol (G) is displayed. 18