Installation • Mark the position of the oil hole in the bearing on the housing. • Heat the engine block to 100 ° C (212 ° F). • Align the mark on the drift (arrow) with the mark on the housing. e Attention: The bearing bushing must not project beyond the oil pockets. The end gap of the bearing bushing must always face the balancing shaft. Before driving in, fit both bearing halves with O-ring on mandrel. • Coat bearing bushings with Optimoly TA and drive in with drift, BMW No. 11 0 551 , working from the inside. 11.44 11 0 551 F110490 F110490