00 13 624 Reading the fault code mem- ory with the MoDiTeC 00 11 209 Changing the engine oil [engine only] and oil filter element (Inspections I, II, III and IV) (Inspection I) L Note: If an engine failure occurs, the oil tank and feed line must be flushed with thin oil, and then blown through with compressed air ( a 11.17). 00 11 209 Preparatory work – Remove cover for belt sprocket from engine. – Place the motorcycle on the auxiliary stand, BMW No. 00 1 620 . 00 11 209 Draining engine oil K14000010 d Warning: Observe the hazard avoidance instructions for run- ning internal combustion engines in enclosed spac- es. – Place the motorcycle on the auxiliary stand, BMW No. 00 1 620 .
• Unclip diagnosis plug (arrow) behind cover on right. • Connect the diagnosis unit to the diagnosis plug. • Read out the fault memory. • Perform any repair work indicated. • Warm up the engine to operating temperature. • Place a suitable container in position to catch the oil. • Remove the oil drain plug from the engine and fully drain the oil from the engine. 00.30