Filling capacity Cooling system ................................................ 1.3 l .............................(2.29 Imp. pints/1.37 US quarts) In expansion tank............................................. 0.1 l .............................(0.18 Imp. pints/0.11 US quarts) Antifreeze Use only nitrite-free long-term antifreeze and corro- sion inhibitor. 1 Concentration Antifreeze.........................................................50% Water ...............................................................50% K14000140 • Run the engine for a short time, then switch it off. • Check coolant level and top up if necessary. • Installation is the reverse of the removal proce- dure:
pay particular attention to the following. • Slacken bleed screw (1) in cylinder head. • Connect a hose to the bleed screw. • Fill the radiator until coolant escapes at the bleed screw; repeatedly squeeze the coolant hoses to expel the air. • Tighten bleed screw (1). L Note: Do not reinstall the cover at this stage, if other main- tenance work has to be performed. X Tightening torque: Stowage-compartment rail to stowage-compart- ment frame..................................................... 9 Nm Cover, rear, to left and right covers and stowage-compartment frame ......................... 2 Nm Right and left covers to air duct .....................
3 Nm Right and left covers to main frame................ 2 Nm Right and left covers to cover, front ............... 1 Nm Right and left turn indicators to fairing bracket3 Nm Drain plug, water pump................................ 10 Nm Expansion tank to radiator ............................. 9 Nm Bleed screw ................................................. 12 Nm Coolant hose to frame.................................... 3 Nm K14000130 • Top up coolant until the level reaches the top of the filler neck (arrow). • Top up expansion tank to the MIN mark. 00.37