BMW Motorrad Maintenance schedule F 650 CS Customer Licence No. Mileage Job Order No. Date Mechanic’s signature BMW Inspection at 1,000 km/600 miles BMW Maintenance Service every 10,000 km/6,000 miles BMW Inspection every 20,000 km/ 12,000 miles BMW Annual Service Read the fault code memory with the BMW MoDiTeC Change the engine oil [engine only] while at regular operating temperature and replace the oil filter element Change the engine oil [engine and oil tank] while at regular operating temperature and replace the oil filter element if motorcycle is used only for short journeys or at outside temperatures below 0°C (32°F):
every 3 months or at the latest after 3,000 km (1,800 miles) Clean oil strainer in frame once only at 10,000 km/6,000 miles Check the coolant and restore to correct level if necessary Grease rubber grommets for cover insert Replace the coolant *) every 2 years Check valve clearances, adjust if necessary *) Replace the spark plug Drain the outlet hose from the air filter box Replace intake air filter If motorcycle is operated in very dirty or dusty conditions, clean or replace the intake air filter every 10,000 km (6,000 miles); check every 3,000 km (1,800 miles) Replace fuel filter every 40,000 km (24,000 miles) Check clutch play, adjust if necessary Examine brake pads and discs for wear, replace if necessary *) Check front/rear circuit brake fluid Check for operation of brake system and freedom from leaks; repair/replace if necessary *) Renew brake fluid at least once a year [ABS] Replace the primary front/rear brake master cylinder cup *) every 40,000 km (24,000 miles) Replace toothed belt Check toothed belt and sprocket, replace if necessary *) Check belt tension, adjust if necessary *) Check battery acid level, add distilled water if necessary Clean and grease the battery terminals, if necessary Check steering head bearings and adjust *) or replace if necessary *) Grease the side stand Using a torque wrench, check that the screws and nuts of the engine mounts, manifold fas- tener, the frame threaded fasteners, the rear-frame threaded fasteners, and the eccentric clamp are tightened to specified torque Final inspection with road safety and functional check:
– Clutch, gearshift – Steering – Front and rear brakes – Side stand contact switch – Condition of tyres and wheels, tyre pressures – Lights and signalling equipment, indicator and warning lights, instruments – Optional equipment – Test ride, if necessary *) Write up on separate invoice; Not part of standard service procedure UX-VS-2, 07.2001 BMW recommends Castrol