K14000490 K14000500 • Use a strap to secure the rear wheel to the rear frame (arrow). • Remove the belt from the belt sprocket. • Working from the front, pass the new belt be- tween the frame and the belt pulley (arrow). K14000510 K14000580 • Slide the belt onto the swinging arm (arrow). • Holding the belt vertical, pass it between the swinging arm and the frame. • Use a strap to secure the swinging arm at the front (arrow). • Remove the swinging arm pivot shaft. • Press swinging arm with rear wheel back and to the left, while pressing the brake caliper forward. • Pull the belt forward and remove. • Installation is the reverse of the removal proce- dure:
pay particular attention to the following. L Note: Grease the pivot shaft of the swinging arm with Optimoly TA before installing. Note the thrust washers when installing the swing- ing arm. d Warning: Do not bend the belt sharply or twist it. Do not bend the belt through a radius of less than 100 mm (3.9371 in). • Preload the new belt and turn it through three complete revolutions of the belt. – Adjust belt tension ( a 00.56). X Tightening torque: Sprocket cover to engine ............................... 2 Nm Eccentric clamp, rear swinging arm Initial torque ................................................. 10 Nm Final torque ..................................................
21 Nm Belt cover to swinging arm............................. 9 Nm Brake caliper to swinging arm ...................... 21 Nm Spring strut to angled lever .......................... 41 Nm Reaction link to swinging arm....................... 41 Nm Pivot shaft of swinging arm ........................ 100 Nm 00.55