Connector PCB Assembly 1 Remove the following assemblies: Toner cartridge, media tray, and cable pod. See “Toner cartridge” on page 15 through “Cable pod” on page 17. Left side, back, right side, and top covers. See “Left side cover” on page 18 through “Top cover” on page 29. 2 Open the toner cartridge door. 3 Disconnect the laser scanner ribbon cable (at the laser/scanner end), laser scanner wire harness, LED status panel wire harness, and ECU ribbon cable. 4 Remove the three connector PCB assembly mounting screws (callout 1), and remove the assembly. 1 Figure 19. Remove the connector assembly 30 Chapter 2 - Removal and replacement Q1342-90910