Supermicro A+ Server 2021TM-BTRF/BIBXRF — Supermicro A+ Server 2021TM-BTRF/BIBXRF User Manual PDF (EN)

Chapter 6: Advanced Chassis Setup 6-10 Drive Bay Installation/Removal Accessing the Drive Bays SATA Drives: You do not need to access the inside of the chassis or remove power to replace or swap SATA drives. Proceed to the next step for instructions. You must use standard 1" high, SATA drives in the system. Note: Refer to the following FTP site for setup guidelines: com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for additional inmformation . DVD-ROM: For installing/removing the DVD-ROM drive, you will need to gain access to the inside of the server by removing the top cover of the chassis.

Proceed to the "DVD-ROM Installation" section later in this chapter for instructions. The SC827 chassis contains four individual motherboards in separate node drawers. Each motherboard node controls a set of three hard drives. Note that if a motherboard node drawer is pulled out of the chassis, the hard drives associated with that node will power down as well. Figure 6-15: Hard Drives and the Corresponding Motherboards MB: B MB: C MB: D MB: A 1 A 1 B 1 C 1 D 6-15 Motherboard Drawer Locations in the Chassis Motherboard B Controls HDDs B1, B2 and B3 Motherboard D Controls HDDs D1, D2 and D3 Motherboard A Controls HDDs A1, A2 and A3 Motherboard C Controls HDDs C1, C2 and C3