Chapter 4: eMotionBlox-40M Typical Output Wiring Example A H J +24 VDC K XIO D-Sub 26 F C 0097 0098 0099 B D 0100 0101 0102 0103 L G 0104 Figure 4-6. Typical User Wiring for XIO Output Signals XIO Breakout Cable The XIO Breakout cable is available as an option—see the following figure. This cable connects to the XIO connector on the eMB-40M, and provides flying leads on the user’s end, for con- necting input and output signals in the workcell. The cable length is 5 m (16.4 ft). See the following table for the cable wire chart. NOTE: This cable is not compatible with the XIO Termination Block. 19148-000 Rev.
E Cobra 450, 500, and 650 User's Guide 39 19 20 21 22 23 K 24 K 25 26 1 10 Key Meaning Key Meaning A Supplied Equipment H User-Supplied Equipment B Outputs 1-8 J Wiring Terminal Block C (equivalent circuit) K Typical User Loads D Signal L Customer AC Power 10 Supply G Ground M Motor (example of a load)