Figure 1- 14. Open pin feed cover Pull the paper up until the top is above the pin-feed holders. Fit the holes on the left side of the paper over the pins in the left holder and close the cover. Fit the right side of the paper in the right holder, mov- ing the holder as needed to match the width of the paper. Close the second cover, make sure the paper has no dips or wrinkles, lock the right holder in place and push the paper bail against the paper. Now you are ready to set the top of page position. Turn the paper- feed knob to advance the paper until a perforation between sheets is approximately 1/8 of an inch below the top of the ribbon guide, as you see in Figure 1-15 . Figure 1- 15.
Top of page position 15