Starting with the Cisco IOS XE Dublin 17.12.1 release, DSCP marking for RADIUS packets is applicable for administrative access sessions such as SSH and Telnet. You can use the aaa authentication global configuration command to define RADIUS authentication for administrative sessions. How to Configure RADIUS Identifying the RADIUS Server Host To apply these settings globally to all RADIUS servers communicating with the device, use the three unique global configuration commands: radius-server timeout , radius-server retransmit , and key string . You can configure the device to use AAA server groups to group existing server hosts for authentication.
You also need to configure some settings on the RADIUS server. These settings include the IP address of the device and the key string to be shared by both the server and the device. Follow these steps to configure per-server RADIUS server communication. Before you begin If you configure both global and per-server functions (timeout, retransmission, and key commands) on the device, the per-server timer, retransmission, and key value commands override global timer, retransmission, and key value commands. Procedure Configuring RADIUS How to Configure RADIUS Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted.
Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 radius server server name Example: Device(config)# radius server rsim Specifies the name for the RADIUS server configuration for Protected Access Credential (PAC) provisioning, and enters RADIUS server configuration mode. Step 4 address {ipv4 | ipv6}ip address{ auth-port port number | acct-port port number} Example: Device(config-radius-server)# address ipv4 124.2.2.12 auth-port 1612 (Optional) Specifies the RADIUS server parameters. For auth-port port-number, specify the UDP destination port for authentication requests. The default is 1645. The range is 0 to 65536. Configuring RADIUS 25