Configuring RADIUS Login Authentication Follow these steps to configure RADIUS login authentication: Configuring RADIUS Configuring RADIUS Login Authentication Command or Action Purpose For acct-port port-number, specify the UDP destination port for authentication requests. The default is 1646. Step 5 key string Example: Device(config-radius-server)# key rad123 (Optional) For key string, specify the authentication and encryption key used between the device and the RADIUS daemon running on the RADIUS server. Note The key is a text string that must match the encryption key used on the RADIUS server. Always configure the key as the last item in the radius server command.
Leading spaces are ignored, but spaces within and at the end of the key are used. If you use spaces in your key, do not enclose the key in quotation marks unless the quotation marks are part of the key. Step 6 retransmit value Example: Device(config-radius-server)# retransmit 10 (Optional) Specifies the number of times a RADIUS request is resent when the server is not responding or responding slowly. The range is 1 to 100. This setting overrides the radius-server retransmit global configuration command setting. Step 7 timeout seconds Example:
Device(config-radius-server)# timeout 60 (Optional) Specifies the time interval that the device waits for the RADIUS server to reply before sending a request again. The range is 1 to 1000. This setting overrides the radius-server timeout global configuration command setting. Note We recommend that you configure timeout under the radius-server timeout command only and not under the aaa group server radius command. Step 8 end Example: Device(config-radius-server)# end Exits RADIUS server configuration mode and enters privileged EXEC mode. Configuring RADIUS 26