Atari Games Cops — Cops TM-398 1st Printing COLOR COVERS_Page_2.jpg

CHAPTER 1 —SET-Up CD-ROM “ Cops OPERATOR’S MANUAL Disc Installation 1. Remove 2. Turn on power to the game. 3. Press the open/close button on the right-hand side 4. the cabinet’s lower rear cover. ID COM 0, 1 (laser disc communicate) CD COM 0, 1 (compact disc communicate) CHKSUM 2B6077 (The exact hexadecimal checksum number displayed will dif- of the small CD player. The tray will slide out. fer, depending on the revision of the ROM software. However, the Pick up the CD-ROM disc by its edges (the smaller of the two discs). Place the disc in the tray with the checksum should always stay the same for one disc. If a checksum label “Side One” facing up. number 5.

Press the open/close button on the CD-ROM player. 6. If the tray does not open, turn off the power, turn it back on again, and push the eject button immediately. Laser Disc Player The laser disc player is the Model LDP-1450 manufactured by Sony Corporation. This player is an industrial version designed for long-term reliability and use. However, problems can occur if the player is subjected to condensation. NOTE The audio and video of the Cops game CD-ROM and laser disc will not make sense if played on a standard home audio CD player or laser disc player. (The audio and video will not be sequential.) However, you will not damage the discs by playing them in such equipment.

Handling Laser Discs Always hold the discs by their edges and keep the discs clean. Do not stick paper or tape on the disc surface. Do not expose the discs to direct sunlight or heat sources (such as hot air ducts) or leave them in a parked car in direct sunlight (where they will experi- is not displayed, you may have a fault.) INSERT COIN The music should then begin playing. If these messages do not appear, you have a problem. See Chapter 3 of this manual for troubleshooting hints. CAUTION You can leave the two discs in their players overnight, if you turn off the power to ail your games each night.

However, do not move, disassemble, or tip the Cops game with the discs still loaded in their players. You could damage the players internally. Filtering and Cooling The Cops game contains an axial fan that provides cooling and air filtration. The air is drawn from inside the cabinet and is filtered to prevent coarse dust particles from entering the cabinet. The air flow also provides cooling for the electronics and monitor. After the cool air has entered the cabinet, it is filtered to remove fine dust particles and is directed towards the laser disc player on the lower shelf.

By drawing filtered air from the lower enclosure (which is only complete when the rear service panel is in place), dust ac- cumulation inside the laser disc player is kept to a minimum. ence high temperatures). Do not use solvents (such as benzene or thinners) or CAUTION commercially available cleaners or anti-static sprays in- To ensure proper operation of this game, tended for audio discs. you should regularly check the condition of the removable filter mesh. If the mesh has Startup Messages dust or dirt on it, you should remove it, After turning on the power and loading the discs, you should see these four messages on the alphanumeric display: stall it.

1-4 wash it in soapy water, let it dry, and rein-