Cops OPERATOR’S MANUAL Inspecting the Game WARNING To avoid electrical shock, do not plug in the cabinet until it has been properly inspected and set up for the line voltage in your area, “ CHAPTER 1 — SET-UP Disc Installation and Handling To avoid damage to the game, the laser and CD-ROM discs are not shipped inside their players. CAUTION This cabinet should be connected to a grounded, three- Do not operate the game right after having transported it from a cold location directly to a warm location or in a room where the wire outlet only. If you have two-wire outlets, we recommend that you hire a licensed electrician to install grounded outlets.
Players can receive an electrical shock if the cabinet is not properly grounded. temperature rises suddenly. Moisture may condense in the operating section of the unit. WAIT FOR 2 HOURS before turning the Make note of the power consumption when you set up this game so that you do not overload your electrical circuit. See Table 1-1 for the power consumption and the other important specifications of this game. power on in the new location, or, to evapo- rate the moisture rapidly, leave the game turned on for at least an hour without the discs loaded. If the game is operated with Inspect your Cops game carefully to ensure that the game is complete and was delivered to you in good condition.
Inspect the cabinet and seat as follows: 1. Examine the exterior of the cabinet for dents, chips, or broken parts. 2. Open the lower-rear access panels. Unlock and open the coin door. Inspect the interior of the cabinet as follows: a. Check that all plug-in connectors on the cabinet harnesses are firmly plugged in. Do not force the connectors together. The connectors are keyed so they fit only in the proper orientation. A reversed connector can damage a printed-circuit board (PCB). This will void your warranty. b. Ensure that all plug-in integrated circuits on each PCB are firmly plugged into their sockets. c. Inspect the power cord for any cuts or dents in the insulation. d.
Inspect the power supply. Make sure that the correct fuses are installed. Check that the harness is plugged in correctly. Check that the green ground wires are connected. e. Inspect other sub-assemblies, such as the video displays, controls, printed-circuit boards, speak- ers, laser disc player, and CD player. Make sure moisture condensation, the laser disc play- er may be damaged. To install the discs, perform the following steps: Unpacking the Discs The factory does not install the CD-ROM disc and laser disc in their players, to protect the player mechanisms.
Instead, the discs are stored in protective cardboard sleeves in the left monitor access compartment (as viewed when you are sitting in the seat). Remove the two screws that secure the left monitor access panel. Open the lock on the panel, and remove the two discs. Once you have installed the discs, you should store the cardboard sleeves in this compartment for future use. Laser Disc Installation 1. Remove the cabinet’s lower rear cover. 2. Turn on power to the game. 3. Press the open/close button on the right-hand side of the large laser disc player. The tray will slide out. 4. Pick up the laser disc by its edges (the larger of the two discs).
Place the disc in the tray with the label that they are mounted securely and that the ground wires are connected. “Side One” facing up. 5. Press the open/close button on the laser disc player.