Ref :UM-CT7-11-001 Issue : 01 Date : 28/04/2011 Page 13 of 35 5.2 CT7 basics 5.2.1 Power ON When performing actual measurements CT7 is not connected to a PC To start, just push the joystick UP Power ON Pressing shortly joystick will toggle the supply ON and start processor start-up. After a short delay, about 3s, the Start-up screen will show up. A few seconds later the CT-7 start screen followed by date and time will be displayed. After next few seconds, the ONE CLICK menu will appear. NOTE: It is vital to set correctly the date and time. If the date and time is not set, the result indexing is not working corrctly.
The CT7 will prevent you from making the measurements and communicating with PC. Time NOT SET >> go to MEASURE / DATE TIME and set date and time This document is OPO property. It may not be either used or copied without authorization. OPO sprl, Crawhez 9, 4890 Thimister Clermont, Belgium. +32 87688989 - +32 87598990