Appendix Roll Die-cut Label (Gap/Black Mark) ❏ Paper without waste parts Black mark width Black mark length Gap between labels Waste part Waste part Black mark center position Paper Print area ❏ Paper without waste parts on the left and right edges (die-cut label with black marks) Black mark length Gap between labels Black mark center position Paper Print area Waste area 364 Label width Paper feed dire Black mark Label corner R 2 mm (0.08 inche or more Perforation Cut Uncut Label length Release liner width Paper feed dir Black mark Label corner R 2 mm (0.08 inch or more Perforation Cut Uncut Waste width Waste part Label width Label length width part Label width Black mark width Item Specifications Die-cut label (Gap) Die-cut label (Black Mark) Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 25.4 to 112 mm (1.00 to 4.41 inches) Label width 21.4 to 108 mm (0.84 to 4.25 inches) Label length 8 to 406.4 mm (0.31 to 16.00 inches)