Appendix • Auto cutting on the perforation lines will generate scraps of paper that may cause problems. Also, auto cutting ahead of the perforation line may cause problems when feeding paper. Therefore, perform auto cutting when paper is fed at least 0.5 to 1 mm (0.02 to 0.04 inches) away from the perforation line. • Place the black mark at least 2 mm (0.08 inches) away from the perforation. • Do not use paper whose gap between labels is outside the specification, as it may cause a paper jam. • Since the black mark detector is not located at the center of the paper width, black marks on both sides can be detected no matter which edge of the paper is printed from.
• Depending on the shape, paper thickness, and hardness of the die-cut label, the label may peel off from the backing inside the product. If you wish to use die-cut labels other than those specified, please contact qualified service personnel in advance. 365 Item Specifications Die-cut label (Gap) Die-cut label (Black Mark) Gap between labels 2 to 6 mm (0.08 to 0.24 inches) Waste part on the left and right 2 +/- 0.5 mm (0.08 +/- 0.02 inches) Waste width - 1.5 mm (0.06 inches) or more Label corner R 1.5 mm (0.06 inches) or less Black mark position - See the above figure.
Leading edge of the mark should be aligned with that of the label Black mark width - 13 mm (0.51 inches) or more Black mark length - At least 4 mm (0.16 inches), With 4 mm (0.16 inches) or more of space around the mark Black mark center position - 8.5 +/- 1 mm (0.33 +/- 0.04 inches) Black mark interval - 10 to 412.4 mm (0.39 to 16.24 inches) Paper thickness 0.159 to 0.240 mm (0.006 to 0.009 inches) Roll core outer diameter • 44.1 mm (1.74 inches) or more (plain paper, matte paper, or synthetic paper) • 56.8 mm (2.24 inches) or more (paper types other than above) Roll paper outer diameter Up to 101.6 mm (4.00 inches) Winding direction The side to be printed must face outward Perforation form 3 to 5 mm (0.12 to 0.20 inches) of slit length with 1 mm (0.04 inches) interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used