Appendix Fanfold Die-cut Label (Black Mark) Black mark width Black mark length Gap between labels Waste part Waste part Black mark center position Paper Print area 366 Release liner width Paper feed dire Black mark Label corner R 2 mm (0.08 inch or more Perforation Cut Uncut Label width Label length Item Specifications Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 50 to 112 mm (1.97 to 4.41 inches) Label width 46 to 108 mm (1.81 to 4.5 inches) Label length 8 to 301.8 mm (0.31 to 11.88 inches) Gap between labels 2 to 6 mm (0.08 to 0.24 inches) Waste part on the left and right 2 +/- 0.5 mm (0.08 +/- 0.02 inches) Waste width 1.5 mm (0.06 inches) or more Label corner R 1.5 mm (0.06 inches) or less Black mark position See the above figure.
Leading edge of the mark should be aligned with that of the label Black mark width 13 mm (0.51 inches) or more Black mark length At least 4 mm (0.16 inches), With 4 mm (0.16 inches) or more of space around the mark Black mark center position 8.5 +/- 1 mm (0.33 +/- 0.04 inches) Black mark interval 10 to 304.8 mm (0.39 to 12.00 inches) Paper thickness 0.161 to 0.240 mm (0.006 to 0.009 inches) Perforation interval 152.4 to 304.8 mm (6.00 to 12.00 inches) Number of folds 500 or less Perforation form 3 to 5 mm (0.12 to 0.20 inches) of slit length with 1 mm (0.04 inches) interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used