Chapter3 Handling • Cut (after printing last label) • Cut (at specified label) • Cut (after last page of collate page) • Do not cut (stop at peel position) • Do not cut (stop at cut position) (Initial setting) • Do not cut (stop at the print end position) c IMPORTANT If you have set to [Cut (after last page of collate page)] and if the printer stops due to a paper jam or other reason while the auto cutter is operating, it is impossible to resume printing. Change the settings for color, barcode, and paper handling. For more details about each menu item, see the Help. • Print Color Adjustment Ink Profile: Print density can be changed to darker or lighter. Ratio of Black to Composite:
Adjust the ratio of black ink to composite black. • Barcode and 2D Symbol Preset Bar Width Adjustment: When using a built-in barcode font, adjust the bar width. • Paper Adjustment Media Hold Pressure: Adjust the paper suction power of the platen. Drying time per head pass setting: Adjust additional time to dry ink. • Bidirectional Printing When enabled, printing is performed when the print head moves to the left or right, resulting in faster printing speed. • If you change the settings in [Print Color Adjustment], and/or [Bar Width Adjustment], it may affect readability of barcodes.
• If you increase the ratio of black ink in [Ratio of Black to Composite], be careful not to touch the printed surface immediately after printing because ink can adhere to your fingers. 91 11 Settings For Paper Handling After Print 12 Advanced