Chapter3 Handling c IMPORTANT • We recommend setting the Left & Right Gap to 2 mm (0.08 inches) or more. If it is set to less than 2 mm (0.08 inches), ink may adhere to the inside of the printer, staining printed material. • Regarding the waste part on the left and right of the label Auto cutter model: The waste parts can be set within a range of 2 to 6 mm (0.08 to 0.27 inches). (They should normally be set to 2 mm (0.08 inches).) Peeler model: The waste parts can be set to 2 mm (0.08 inches) only. * If they are set larger than 2 mm (0.08 inches), problems such as paper jams might occur. Select the form of the paper.
( "Paper Specifications" on page 362 ) 80 5 Left & Right Gap The gaps on the left and right are always Left & Right Gap. 5 Left & Right Gap The gaps on the left and right are always Left & Right Gap. 5 Left & Right Gap the 6 Media Form