Chapter3 Handling Select a media saving setting. The [Media Saving] function eliminates margins from one-page print data to suppress wasting paper. c IMPORTANT Even if [Media Saving] is set to "Eliminate Lower Margin" or "Eliminate Lower and Upper Margin", the setting will be disabled when data for the barcode font replacement is included. Top margin Bottom margin Print data Paper feed direction • No Saving: Paper is fed before starting printing and after completing printing, creating top and bottom margins on the printout. • Eliminate Lower Margin: Paper is not fed after completing printing, and thus a lower margin is not created on the printout. • Eliminate Lower and Upper Margin:
Paper is not fed before starting printing or after completing printing, and thus lower and upper margins are not created on the printout. If you set the printer to cut paper in the [Settings for Paper Handling After Print] setting, paper length of at least 15 mm (0.59 inches) is required. When the length of print data is less than 15 mm (0.59 inches), the margins are not eliminated even if you have set to [Eliminate Lower Margin] or [Eliminate Lower And Upper Margin]. Print data length Minimum paper length:
15 mm (0.59 inches) Margin If your print data includes labels of various sizes, printing can be performed using label lengths optimized for the print data by setting the label (page) size to the largest value and then using the [Media Saving] function. Select the media coating type. ( "Paper Specifications" on page 362 ) 81 7 Media Saving (for continuous paper and continuous label only) 8 Media Coating Type