Chapter 3 Commands Mode setting for printer ready signal (output) [Format] ^S(CNA,O,c [Parameter] c [Function] Configure the mode settings for the printer ready signal. [Initial value] 0 [Examples of command transmissions] 3 Set the printer ready signal to "Normal: High, When printer is ready: Low". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNA,O,1 ^JUS ^XZ 29 Description Definition range c = Mode setting D/E/0/1/2 Value for parameter c Description D/0 Turn the printer ready signal (pin 19) OFF (not output).
1 Set the printer ready signal (pin 19) as follows: Normal: High, When printer is ready: Low. E/2 Set the printer ready signal (pin 19) as follows: Normal: Low, When printer is ready: High.