Chapter 3 Commands Mode setting for feed signal (input) [Format] ^S(CNI,F,c [Parameter] c [Function] Configure the mode settings for the feed signal. [Initial value] 0 [Examples of command transmissions] 3 Set the feed signal to "Feed the label as long as a Low signal is input". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNI,F,3 ^JUS ^XZ 38 Description Definition range c = Mode setting 0/3 Value for parameter c Description 0 Ignore the feed signal (pin 11). 3 Set the feed signal (pin 11) to the following mode:
Feed the label as long as a Low signal is input.