Chapter 3 Commands Mode setting for start print signal (input) [Format] ^S(CNI,S,c [Parameter] c [Function] Configure the mode settings for the start print signal. 3 [Initial value] 0 [Examples of command transmissions] Set the start print signal to "Print labels when a Low signal is input for 30 msec or longer". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNI,S,1 ^JUS ^XZ 39 Description Definition range c = Mode setting 0/1/3 Value for parameter c Description 0 Ignore the start print signal (pin 10).
(Normal print mode in which the printer receives and prints data, without using the start print signal input to the external I/O.) 1 Set the start print signal (pin 10) to the following mode: Print labels when a Low signal is input for 30 msec or longer. 3 Set the start print signal (pin 10) to the following mode: Print labels as long as a Low signal is input.