Appendix Roll Full-page Label/ Roll Full-page Label (Black Mark) Paper feed direction Black mark center position Label area Paper Cut position Black mark Black mark length Black mark width Waste part Waste part • To prevent adhesive from adhering to the roll paper supply unit, use label paper from which the left and right wasted parts are removed. • Since the black mark detector is not located at the center position of the paper width, if there are black marks on both sides of the paper, black marks will be detected no matter which side of the paper you print from.
374 n n Release liner width B le Label width Label width paper width Black mark interval Item Specifications Without black marks With black marks Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 25.4 to 112 mm {1.00 to 4.41 in.} (Internal) 50 to 112 mm {1.97 to 4.41 in.} (Rear Feed) Label width 21.4 to 108 mm {0.84 to 4.25 in.} (Internal) 46 to 108 mm {1.81 to 4.25 in.} (Rear Feed) Waste part on both sides 2 ± 0.5 mm {0.08 ± 0.02 in.} Black mark position - See the above figure Black mark width - 19 mm {0.75 in.} or more Black mark length - 4 to 25.4 mm {0.16 to 1.00 in.}, with 4 mm {0.16 in.} or more of space around the mark Black mark center position - 12.4 mm {0.49 in.} Black mark interval - 11 to 1016 mm {0.43 to 40.00 in.} Auto cut is not possible when the length of the paper is less than 15 mm {0.59 in.}.
Paper thickness 0.159 to 0.240 mm {0.006 to 0.009 in.} Roll paper core inner diameter 76.2 ± 0.5 mm {3.00 ± 0.02 in.} Roll core outer diameter 82.2 mm {3.24 in.} or more Roll paper outer diameter Up to 203.2 mm {8.00 in.} Winding direction The side to be printed must face outward Holes and cutouts Paper with holes or cutouts cannot be used