Appendix Roll Die-cut Label (Gap/Black Mark) Paper feed direction Label area Paper 2.0 mm {0.08 in.} or more Corner R Black mark Waste part Black mark width 375 on Perforation Cut Uncut Gap betwee labels Label length Black ma length Label width e Item Specifications Die-cut label (Gap) Die-cut label (Black Mark) Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 25.4 to 112 mm {1.00 to 4.41 in.} (Internal) 50 to 112 mm {1.97 to 4.41 in.} (Rear Feed) Label width 21.4 to 108 mm {0.84 to 4.25 in.} (Internal) 46 to 108 mm {1.81 to 4.25 in.} (Rear Feed) Label length 8 to 1016 mm {0.31 to 40.00 in.} Auto cut is not possible when the length of the paper is less than 15 mm {0.59 in.}.
Gap between labels 3 to 6 mm {0.12 to 0.24 in.} Waste part on both sides 2 ± 0.5 mm {0.08 ± 0.02 in.} Label corner R 1.5 mm {0.06 in.} Black mark position - See the above figure.
Leading edge of the mark should be aligned with that of the label Black mark width - 19 mm {0.75 in.} or more Black mark length - 4 to 25.4 mm {0.16 to 1.00 in.}, with 4 mm {0.16 in.} or more of space around the mark Black mark interval - 11 to 1016 mm {0.43 to 40.00 in.} (When auto cutting is not performed) 18 to 1016 mm {0.71 to 40.00 in.} (When auto cutting is performed) Paper thickness 0.159 to 0.240 mm {0.006 to 0.009 in.} Roll paper core inner diameter 76.2 ± 0.5 mm {3.00 ± 0.02 in.} Roll core outer diameter 82.2 mm {3.24 in.} or more Roll paper outer diameter Up to 203.2 mm {8.00 in.} Winding direction The side to be printed must face outward Perforation form 3 to 5 mm {0.12 to 0.20 in.} of slit length with 1 mm {0.04 in.} interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used