Chapter3 Handling Configure color correction settings. For more details about the color correction, see "Color Correction" on page 273 . • Epson Preferred Color The color correction engine in the printer corrects colors to produce print results that are close to those seen on a typical LCD monitor. The colors are similar to Epson Standard colors, but differ in that CMY ink colors can be printed as they are. • Epson Standard The color correction engine in the printer corrects colors to produce print results that are close to those seen on a typical LCD monitor. • Epson Vivid Color The color correction engine in the printer corrects the color to a vivid shade suitable for labels.
The color tones are different from those of typical LCD monitors. • ICM The color correction engine in the OS corrects color tints according to the ICC profile corresponding to the currently set paper type and print speed. With the appropriate ICC profile, the tint on the LCD monitor can be matched to the tint of the printed result. • No Color Adjustment Select this setting if your application software performs color correction. The printer does not perform color correction. This function allows you to change a specific color to a specified color. For more details about the spot color setting, see "Spot Color Settings" on page 267 .
• Cut (after printing last label) • Cut (at specified label) • Cut (after last page of collate page) • Do not cut (stop at cut position) (Initial setting) • Do not cut (stop at specified position) You can change the [Print Color Adjustment], [Barcode and 2D Symbol Preset], [Paper Adjustment], and [Edge Adjustment] settings. For explanation of each setting, refer to the Help. • Print Color Adjustment Ink Profile: Print density can be changed to darker or lighter. Ratio of Black to Composite: Adjust the ratio of black ink to composite black. • Banding Reduction: If color banding occurs, adjust the ink density. • Barcode and 2D Symbol Preset Bar Width Adjustment:
When using a built-in barcode font, adjust the bar width. • Paper Adjustment Media Hold Pressure: Adjust the paper suction power of the platen. Shrink correction in the paper length direction: If the print result shrinks in the paper length direction, set the correction value. • If the paper type is high glossy paper or glossy film, the [Banding Reduction] function may not be able to reduce color banding so much. Please examine print quality with the paper well before using it. • The length of the print data is increased up to 1016 mm {40.00 in.} in the paper length direction according to the correction value set in [Shrink correction in the paper length direction].
If the paper length exceeds 1004 mm {39.92 in.}, the correction result will not follow the correction value and a length exceeding 1016 mm {40.00 in.} cannot be set. 96 11 Color Correction Mode 12 Spot Color Setting 13 Settings For Paper Handling After Print 14 Advanced