Chapter 2 Setup 3 Connect the cable to DP-110, computer, and TM printer to match the constructed environment. (See "Connecting" on page 74 ) 4 Arrange the cables as shown below. Put the cables inside the DP-110. For the RS-232/USB model, the end of the connector of the unused cable should be capped, and then bundled to be stored inside DP-110. 2 5 Attach the base plate to the DP-110 following the numbered arrows shown below. Then push the base plate until it is locked by the hook on the DP-110. The plate is locked by the hook. 6 When the extension support (DP-105) is used, attach affixing tapes to the four corners of the plate to keep the unit from falling down.
7 When using the AC adapter, insert the power cord to the AC adapter, and then insert the power cord to the outlet. 34