Chapter 2 Setup DP-502 (TM-H6000V) • Set DIP switch 2-2 on the printer to "ON". • Set "Selection of interface using the customer display" on the printer according to the inter- face that is used. Checking the accessories Check the DP-502 parts. When attaching to the TM-H6000V, use the following parts. Stopper Fixing screw for stopper Fixing plate B Installation Guide Angle fixing screw 2 Fixing screws for rubber feet (small) Rubber feet (small) Fixing screws for fixing plate B Support C Support B for extension Fixing plate A 38