Chapter 2 Setup Serial (USB controlled) DM-D110/DM-D210 Ferrite core USB cable Cap RS-232 cable Not connected Not connected USB cable AC adapter Computer DP-110/DP-210 Power cord TM Printer 2 ∗ Not available for the RS-232 model. When connecting the RS-232 cable to the TM printer, make sure that the AC adapter is not con- nected to the TM printer. If the RS-232 cable is connected to the TM printer to which the AC adapter is connected, the product may be damaged. CAUTION Connect the RS-232 cable to the DM-D connector on the interface side of the TM printer. Do not connect to the TM printer’s DM-D connector.
79 • DM-D110 • DM-D210 USB cable * • Do not remove the cap (factory default condition) • Not used (bundle inside DP-110/DP-210 or DP-502/DP-503) RS-232 cable • Remove the cap * • Attach the ferrite core * • Connect to the DM-D connector of the interface board which i s installed to the TM printer • DP-110 • DP-210 DM-D connector Not used Power supply connector Not used Extension power cable connector Not used Computer interface connector Not used Printer interface connector Not used JP1 Not setting JP2 Not setting