Downloaded from https://www.everyspec.com MIL-STD-3001-4(AS) l. Lubrication . m. Assembly n. Test and inspection test-inspect >. o. Installation . p. Rigging rig >. q. Adjustment . r. Calibration calibrate >. s. Preparation for storage or shipment . t. Environmental conditioning envircond >. u. Safety information safe >. v. Engine start and run-up engstart >. w. Software loading softload >. x. Fabrication fabricate >. y. Packing packing >. z. Unpacking unpacking >. aa. Preservation preserve >. ab. Tracking track >.
To enhance usability and clarity, all authorized maintenance tasks for a specific system, subsystem, equipment, or component may be contained in a single work package or may be provided in a series of work packages. For example, all authorized maintenance tasks may be placed in a single work package or removal and installation may be included in one work package and disassembly, inspection, and assembly may be placed in a second work package. Division of work packages or selection of coverage will depend on various factors including but not limited to: a. A WP may be determined by the operational modes, complexity of the maintenance action, or level(s) of maintenance covered. b.
Two or more WPs for an identical maintenance task may be required because the task is performed differently due to differences in configurations. c. Development of more than one WP because the reduction in the size of the work package would make it more useable. d. Development of one WP consisting of information that should be kept together because dividing the information into several work packages would degrade the usability. e. Separate WPs due to different initial setup information for a set of maintenance tasks for a repairable component. 5.3.1.1.1 Maintenance task requirements.
Additional mandatory or unique technical information requiring additional explanations for the maintenance tasks listed in 5.3.1.1 above is described in 5.3.1.1.2 through 5.3.1.1.16. The following general requirements apply to most of the maintenance tasks listed in 5.3.1.1 above. a. Instructions shall be prepared for any peculiar installation of lockwire, cotter pins and use of sealing compounds, lubricants, or corrosion prevention compounds. b. If servicing (i.e., pressurizing and charging with gas, lubrication, etc.) is required upon completion of a maintenance task, include this information as part of the task. 8