Downloaded from https://www.everyspec.com Various powered mechanisms have been devised to obviate or minimize the manual effort required in feeding and loading operations for cannon. Re- cent designs in service include power operation in: mechanical ramming of the projectile only (for separate loading ammunition), mechanical fuze setting and ramming of the projectile and case (for separated ammunition), and automatically controlled mechanical feeding and ramming of fixed ammunition.
The latter combines with the automatic actions of vertically sliding breechblock gun's or of bolt-type breech mechanisms to provide continuous overall cycling (automatic firing) or cycling complete except firing (semiautomatic fir- ing). (The continuously cycling weapons should be termed automatic only if power for all the mechanism is derived from the propellant, by recoil, or other means, see paragraph 3-6.2.) General fea- tures of typical mechanical feeding, loading or combined devices are as follows:
3-8.1.2 Automatic Feeding and Loading tile into the chamber; and suitable hydraulic con- trol piping and valves to govern the sequence of extension of trough, advancement and retraction of rammer chain and head, and folding withdrawal of the trough to clear the path of gun recoil. Hy- draulic pressure is supplied by the gun elevating system. The upper straight section of the chain casing is open and channeled to guide the rammer chain and head in line with the gun bore; the trough, in unfolded position, forms an extension of the guiding channel.
The rammer chain links are so hinged together as to prevent buckling when pushing the head in the straight channel, but to permit meshing with and flexing downward around the sprocket, so that on retraction of the chain, its rear end slides forward in the lower section of the chain casing. The rammer head incorporate« a hydro8pring-type buffer to reduce shock at the end of the rammer stroke. A system of shaft, clutch, stops and rods connected to the ramirer operating mechanism provides for automatic cut-off of ram- ming force at a preset length of stroke. The ramming and withdrawal strokes are initiated by manipulation of a control handle.
For placing heavy projectiles in the trough, a manually oper- ated winch and davit are used. The propellant is manually inserted after the projectile has been rammed. * 3-8.1.2.2 Powered Hydraulic-spring Rammer A typical hydraulicspring rammer (Figure 3- 19) comprises a hydraulic cylinder and piston that Figun 3-18. Ramming Mechanism, Chain Rammer, Hydraulic Power 3-8.1.2.1 Powered Chain Rammer HYlttAUlIC JtA* INOTCATC* RfLfAM '«AMMO/ PMHCTta CVUN0«/1' MCK A typical arrangement (Figure 3-18) suitable for large bore cannon using separate loading am- munition rams the projectile only.
Its principal elements are a chain casing of straight-sided loop profile, with pedestals for fixed mounting, serving as support for the operating parts; a rammer chain with a buffer head, meshed with a sprocket sup- ported in the rear end loop of the casing; a re- versible hydraulic motor attached to the chain casing and driving the chain sprocket to push for- ward, and to retract, the chain and buffer head; a hydraulically operated folding trough hinged to the forward end of the casing to guide the projec- THROWING- SHON C) 1 I AHM CM -tANOLf •/*} JTHUCrWING Figun 3-19. Rommw, Hydraulic-spring Typ» 3—17