US Army Materiel Command AMCP 706-250 — AMCP 706-250 Guns—General Engineering Design Handbook (1964) PDF (EN)

Downloaded from https://www.everyspec.com CHAPTER 5 INTER-RELATION WITH PROPELLANTS 5-1 General Considerations The motion of the projectile at departure from the gun muzzle is the net result of the forces applied to the projectile by the propellant, the inertia of the projectile, and mechanical interaction between the gun and the projectile as the latter passes through the bore.

The summation of the forces applied by the propellant is dependent on (1) the quantity of gases produced; (2) the rate and amount of heat evolution; (3) the volume and rate of change of the space in which the gases are confined while exerting pressure on the projectile; and (4) the cross sectional area of projectile on which the gases apply accelerating pressure. From the combination of propellant properties and gun geometry involved, it is apparent that the problems in gun and ammunition design are mutually de- pendent, one upon the other. this handbook discussion is therefore limited to such considerations as may serve to clarify the relation- ship of gun and propellant designs.

Propellants for guns are classed as low explo- sives, i.e., explosives which, when used under the in- tended conditions, burn rather than detonate. A detonation produces a destructive shock effect and characterizes high explosives. Propellant charges may contain high explosives for increased power, but the properties of the final mixture must permit combustion of the mixture without subjecting the gun and projectile to the shattering effect of deto- nation. Quite a number of propellant compositions have been standardized for use in Army guns. The propellants currently most used in Army guns in- clude:

single j base propellants, consisting princi- pally of nitrocellulose; double-base propellants, basically nitrocellulose and nitroglycerin; and triple-base propellants, basically nitrocellulose, ni- troglycerin and nitroguanidine. Standard compo- sitions contain minor quantities of other ingredi- ents for desired effects on various characteristics, including chemical stability, hygroscopicity, heat of explosion, rate of combustion, muzzle flash, ero- sion, smoke production, residue, electrical conduc- tivity, moldability, strength of grain structure and facility of manufacture.

Generally, for a required weight of projectile, a number of combinations of gun geometry and pro- pellant charge may be found to satisfy the muzzle velocity requirements; then a preferred combina- tion may be selected on the basis of appropriate considerations of weight, size, producibility, re- liability, operability, material availability, cost, and such other factors as may be pertinent in the indi- vidual case. Various properties and characteristics of pro- pellants and considerations of gun-propellant rela- tionships that affect the performance obtained from the combination of gun and propellant are pre- sented briefly below:

5-2.2 Total Energy The total energy developed through combustion of a propellant in a gun is expended as follows: 5-2 Propellant Composition and Characteristics 5-2.1 Composition (1) In expansion of the produced gases, to: (a) accelerate the projectile to exit velocity; (b) accelerate the gun (and other recoiling parts) to the velocity of recoil; (c) translate the propellant gases (and any residue) ; (d) perform the work of The formulation and design of propellant charges are covered in other handbooks of the Series. In