Downloaded from https://www.everyspec.com projectile engraving and overcoming friction of projectile travel in the bore; and (e) overcome friction and other resistances to movement of the gun in recoil. of nitrocellulose is made adequate by addition of various other materials, as coatings or dispersed ingredients. The stability requirement necessarily affects, to some degree, the volume of the chamber. Most of the additions commonly used for stability are also helpful for other purposes, such as reduc- tion of flame temperature, erosion and flash, or simplification of manufacture. (2) In heat lost by:
(a) raising the tempera- ture of the gun, projectile and case (if used) ; and (b) discharge of hot propellant gases (and any residue) on exit of the projectile from the muzzle. Consideration of the expenditures of energy indicated above, with the factors given in para- graph 6-1.1 affecting the energy spent on the pro- jectile, emphasizes that the propellant characteris- tics and the dimensions of the gun chamber and bore, in combination, determine: (a) the kinetic energy imparted to the projectile; (b) the maxi- mum temperature and pressure developed; (c) the exit temperature of the propellant gases; and (d) the total energy that must be evolved to obtain the required projectile motion.
Hence, for optimum overall results, it is imperative that gun and pro- pellant charge designs be fully coordinated. 5-2.5 Mechanical Properties The time required to burn a charge of propellant depends, to a significant degree, on the size and shape of the propellant grains. Hence, the grains should not only be strong and tough enough to endure the loads and impacts incurred in transpor- tation and handling before firing, but should with- stand the pressures, motions and impacts developed in the chamber and tube without shattering before burning has been virtually completed.
5-2.6 Feasibility of Manufacture 5-2.3 Burning Rate and Pressure The propellant designer's choice of materials is limited by the necessity for production of large quantities of propellants during national emer- gencies. The manufacturing processes should be as simple and reliable as possible, and capable of application to large quantity production without compromise in quality and uniformity of product. All operations should be as nearly free from hazard as possible. As far as practicable, products and manufacturing processes should be similar to those normally used in industry, so that production may be more readily expanded where necessary.
When combustion takes place in a closed space, as in a gun, the combustion rate increases rapidly as the temperature and pressure of the confined gases rise. For effective designing of guns to ob- tain prescribed performance, weight and size char- acteristics, the rate of pressure rise and the maxi- mum pressure must be restricted to appropriate limits. The propellant designer controls these effects by: selection of basic propellant constitu- ents; addition of combustion retardants; selection of size and shape of propellant grains; and estab- lishment of the chamber volume to be provided in designing the gun.
The cost of a propellant should be the lowest consistent with provision of the required behavior characteristics. A relatively high cost may be caused by limited supply of basic material or by complicated and costly processes of manufacture. However, when comparing propellant costs, the designer should consider costs per unit of usable energy rather than per unit of weight. Further, differences in temperature, pressure and expansion space required for best use of various compositions may entail such differences in the weight and cost of the required gun structure as to substantially affect the choice of propellant on an overall cost basis.
5-2.7 Costs 5-2.4 Stability Effective service performance of the gun-propel- lant combination requires that the propellant action on firing shall not vary appreciably as a result of storage between manufacture and firing. Hence, chemical stability must be considered a major ob- jective in the design of a propellant. The nitrocellulose compounds used as basic in- gredients of currently used propellants have less inherent stability than is desirable, but materials having their desirable properties plus greater sta- bility are not adequately available. The stability