US Army Materiel Command AMCP 706-250 — AMCP 706-250 Guns—General Engineering Design Handbook (1964) PDF (EN)

Downloaded from https://www.everyspec.com When the projectile passes the holes, a portion of the propellant gas passes into the chamber cre- ating a considerable pressure. When the projectile leaves the muzzle the major portion of the propel- lant gases follow, and pressure in the bore drops below that in the evacuator chamber. The gas content of the chamber then discharges through the drilled passages into the bore and thence out the muzzle, the passages being inclined inward toward the muzzle to obtain a jet action. Mean- while the breech starts to open, and the jet dis- charge at the muzzle induces a flow of air into the breech and forward through the bore.

Size and location of the evasuator chamber and passages must be carefully determined to obtain effective flow in proper timing with breech opening action. ing temperature rise increases with the rate of firing, as the cooling interval between shots de- creases correspondingly. Temperature rise gener- ally increases also as bore diameter decreases, as the latter is normally accompanied by decrease in tube thickness and consequent decrease in the quan- tity of metal absorbing and dissipating heat from each unit of bore area.

Hence, temperature rise becomes a major consideration in the design of automatic rifles and machine guns in the small arms category, and of automatic and semiauto- matic cannon in the lower range of bore diameter. In addition to the effects of temperature on the mechanical properties of materials, the differences in coefficients of expansion with temperature re- quire consideration when unlike materials are used for contiguous or closely clearing parts.

Care must be exercised to avoid the possibility that differen- tial expansion or contraction within the design temperature range may cause looseness, or excessive stresses, misalignment, binding or interference of parts, or other conditions preventing satisfactory functioning or endurance. 6-2.10 Space Limitations The desirability of minimum practical bulk in all guns assumes major importance in weapons intended for mobile mounts, and particularly for installation in tanks, aircraft, or other vehicles where internal space is limited by the necessity for presenting the smallest possible overall silhouette and maintaining a high degree of mobility.

An increase in size of the gun or of the space necessary for its operation is reflected in increased area, hence increased weight, of armored enclosure. This in turn requires a larger and heavier vehicle for support, and greater power to provide desired mobility. Hence, a relatively moderate reduction in space requirements for the gun may effect a significant saving in the overall weight of the complete weapon, decrease its vulnerability, and so reduce both the cost per complete weapon unit and the number of units required to maintain a given degree of military effectiveness.

6-2.12 Manufacturing Limitations To insure full effectiveness of a particular gun design, the relative number to be produced should be considered in connection with the manufactur- ing operations necessary to produce it, and available facilities for performing the operations. Require- ments for operations requiring special types of production equipment, unusual techniques, and difficult degrees of accuracy should be minimized, particularly for large production items, in order to broaden the field of industrial plants capable of production of parts or complete items without in- curring excessive waste of man-hours and material through rejections of defective items.

6-2.11 Temperature The wide ranges of temperatures at which guns are required to function satisfactorily and with- stand storage without damage (extreme range 150° to 70° F) necessitate consideration of the proper- ties of the structural materials at all temperatures in the required range. Further, for tubes, barrels, chambers, and other parts that directly or in- directly absorb heat from the propellant, the effects of temperatures attained from this cause must be taken into account. The importance of this operat- 6-2.13 Strategic Material Limitations So far as possible, guns should be designed for construction with materials that will be available in sufficient supply under war conditions.

Where practical, designs should be suitable, or readily modifiable, for effective use of alternative or sub- stitute materials of better availability, when such procedure becomes necessary to improve the bal- ance of national supply and demand for materials or production facilities.