Downloaded from https://www.everyspec.com and in extremes of field temperatures; withstand high temperatures and pressures; and should have high degrees of durability and freedom from de- terioration in storage. A design completely fulfill- ing all these requirements to the desired degree has not been produced to date, and better materials and improved devices are being continually sought. Flash may be coinbatted by muzzle attachments of either the "flash hider" type (Figure 5-2) or the "flash suppressor" type (Figure 5-3) or an attachment combining these two types may be used. The two types are described in Chapter 5.
6-2.8.3 Muzzle Brakes Where both blast deflection and reduction of recoil energy are desired, both effects may be ob- tained by use of a muzzle attachment designed to turn and deflect a large portion of the muzzle blast sideward and rearward (Figure 6-1). The blast- deflecting vanes, in such case, are designed to re- ceive as much forward pressure as is practicable from the gases, and this pressure becomes effective in reducing the net recoil impulse imparted to the gun by the propellant gases.
Since it is impractical to obtain complete com- bustion of the propellant within the gun, or to approach complete use of the pressure generated, the propellant gases emerge from the muzzle with high velocity and at fairly high temperature.
If appreciable combustion persists as the propellant emerges from the muzzle, flash will be evident; and if the temperature is sufficiently high the flash may be augmented by further combustion of gases by combination with atmospheric oxygen 6-2.8 Blast and Flash 6-2.9 Bore Evacuation In some cannon installations, notably tank and other vehicular mounts, it is necessary to prevent rapid contamination of air in the firing compart- ment by propellant gases emerging rearward from the bore when the breech is opened.
Some large caliber weapons using separated ammunition have been equipped with a compressed air system ar- ranged for discharge of air through the bore to sweep out residual gases before opening the breeeh. Need for a simpler and less space-consuming sys- tem for vehicle installations prompted development of the currently used "evacuator" (Figures 6-1 and 6-2). This system utilizes a cylindrical jacket fitted around the gun tube near the muzzle so as to form an annular chamber outside the tube, and a series of small drilled holes through the tube wall for restricted flow of gas between the gun bore and the annular chamber.
Excessive blast can cause distress and reduced efficiency of the operators, and may have unfavor- able effects on adjacent personnel and equipment. Obscuration of the vision by violent projection of combustion products into the atmosphere, and by dust raised by air disturbance, may prevent effec- tive aiming of successive shots, as well as indicate position to the enemy. Current means of reducing these effects consist of muzzle attachments of vari- ous designs, called blast deflectors, that serve to divert considerable portions of the blast to right and left, reducing the upward and downward air disturbance (see Figure 6-1). 6-2.8.1 Blast Figure 6-1.
Combination Blast Deflector and Muzzle Brake, With Evacuator Chamber 6-2.8.2 Flash Visible flash also serves to betray position to opposing forces,- and produces a blinding effect unfavorable to a rapid succession of aimed shots. Figure 6-2. Schematic Diagram of Bore Evacuator Opera- tion >