— AMCP 706-286 — Engineering Design Handbook (1963) (EN)

Downloaded from https://www.everyspec.com I' 7- STRUCTURES 3-7.3. Rectangular Plates with Free Edges. sh;.pe of the stress distribution curve. Tne The control surfaces of ms;.siles can often be stress is considered positive .%hen it is coin- considered as flat plates of constant or var- pressive. Buckling takes place when able thickness with three edges completely G = C I (3 54) free and the fourth constrained elastically where GC is 'he St. Venant torsional rigidity (see Figure 3-9).

If the atresses a acting in of The plate and the x-direction atid caused by non-uniform b rises in temperature are distributed as shown I -- _ hy-f(y)dy (3 55) in the figure, the control surface is likely to-b buckle in a torsional mode when the stress Thin integral can always be evalua;teJ graph- intensity becomes sufficiently high." The ically or numerically without difficulty. When stress can be given as the plate thickness is constant, , - =ўof(yl (3 53) GC. . = (2 3)h~b( (3 56) where a. is a conttant while f(y) defines the and G is the shear modulus of the material. 1~PPI COMPIRESSION TENS10 O b- b cYf(y) Figure 3-9.

Assumed Stress Distibulion in Reciangular Flat Plafe with Free Edges 3-7A. Thin Circular Cylindrical Shells. In tures become very high. order to simplify the problem of thin circular cylindrical shells one may consider separately The situation is different when the tern- three cases of temperature and thermal perature varies only in the circumferential stress distribution. First, the temperature direction and remains constant through the can vary through the wall thickness, but re- wall thickness and with the axial coordi. main constant along the axis of the cylinder nate.1" A typical situation of this kind arises and around the circumference.

In this case when a circular cylindrical shell is stiffened thermal buckling does not occur. by means of a number of internally arranged When the temperature i.. independent of stringers whic are parallel to the axis of the the circumferential cocrdinate and is con- cylinder.

if aerodynamic heating raises the stant through the wall thickness but varies skin tempera'-re vry rapidly and the heat with the axial coordinate, the resulting hoop flow to the stringers is relatively slow, the compression can, in principle, cause buckling, stringers are subjected to tensile stresses Investigations have shown," ' however, and the shell wall to compressive thermal that under the practical conditions'of ballis- stresses in the axial direction.

Under these tic missile design the danger of elastic buck- stresses the shell wall backles when the aver- ling is very remote and that at most some age intensity of the stress reaches approxi- localized inelastic dimpling may occur near mately the critical value given in Eqiation restraining ring frames when the tempera- (3-25). , /N 50