— AMCP 706-286 — Engineering Design Handbook (1963) (EN)

Downloaded from https://www.everyspec.com S T RESS ANALYSIS 3.8. CROff EMFECTS co.position of the material. but also by heat When the upper end of a vertically ar- treatment and cold work. For this reason r:nged tensile te.4 specimen i4 attached to a care should be taken in the application of rigid frame, and a weight is suspended from creep formulas; they may be valid for a its lower end, the observer can measure an material before, but not after the manufac- instantaneous elastic, and possibly a plastic turing process. elongation at the -noment the load is applied. Figure 3-10 presents the usual shape of If the temperature of the specimen is suffi.

*he creep curve as obtained in a tensile test ciently high, the instantaneous elongation is carried out under a constant load Ft constant followed by furiher elongations which in- temperature. rhe instantaneous deformation crease with time even though the load re- is followed by a period of creep at decreasing mains constant. These elongations are desig- rates of strain, the so-called primary, or Pated creep deformations. transient, stage of creep.

After a while the The physical laws governing creep have time rate of strain becomes constant; the cor- not yet been explored sufficiently to explain responding straight line in the diagram rep- completely the reasons for creep and to pre- resents the secondary, or steady, stage of dict accurately the creep deformations under creep. Finally the creep rate increases again prescribed conditions of loading. Moreover, in the tertiary range until the specimen fails creep is influenced not only by the chemicai by fracture. ISTRAIN I )' SECONDARY T R Y INSTANTANEOUSAR TIME Figure 3-10. Tensile Creep Curve 3-8.!. Secondary Creep.

The greatest In these formulas k, I,, C and n are con- I amount of information is available today on stants. Of these, k has the dimension in. per secondary creep. For a given material the in. per unit time, the dimension of ). is that creep strain rate d, 'dt depends only on the of a stress, the dimension of C is the recipro- stress and tLa temperature (t is time). On cal of a stress, and n is a number.

Results of the basis of test results it appears possible to creep tests carried out witl a material in a represent the creep rate as the product of a given condition of heat treatment and cold function f(a) of the stress a and a function work indicate which one of the three forms V F(T) of the temperature T: is most suitable for an analytic r-en:-senta- " de dt = f(()F(T) (3 57) tion. When the form is selected, the constants d t )((5 can be chosen to obtain the best possible fit h The most genm, ally accepted forms of f(. The: of the empirical curve with the test points. Sare: The form of the function of the temperature f ( . ).

(3 58) is usually given as f() = (3 59) F(T) =eu T f.(s) - i sn h C~a (3 60) 56 r.,o