US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com BREECUH CRADLE -TUNO A. - A- 1 CYLINDER SECT.OR A-A Figure 2. U-Type Cradle With Attached Recoil Mechanism CY~mNER \ :\x \ x~x 'RCOILRO GUNTUBE BREECH A - RAIL- CYLINDER ECOIL ROD A SECTIONi A-A Figure~ 3. (J.Type Cradle With Integral Recoil Mechanism 11. The sliding surfaces of the recoiling the proper alignment and fit parts are called rails. Either the rails or their Production costs are high. supporting guides may be channel-shaped to b. If clearances are not sufficient for prevent them from separating due to the up- an underslung recoil mechanism, setting moments and rifling torques.

Either, the trunnion height must be in- but not both, may be discontinuous, that is, creased, with an accompanying made of several shorter lengths spaced at con- increase in overturning moment venient distances. Rails may Le ,ttached to and a higher silhouette. the sleigh. Whichever is used, the s'm irl rail c. It is difficult to arrange the ideal assembly or the sleigh, although not constit- loading pattern with the resultant uent parts, each should be treated as a corn- of the recoil forces passing ponent of the cradle. through the centerline of the 12. The U-type cradle has several ad- trunnions. This arrangement is vantages.

With a sleipgh, the added weight of always attempted in order to min- the recoiling parts reduces either recoil force imize the elevating gear loads dur- or length of recoil. Ordinarily, the height of ing recoil. the weapoa is decreased (lower silhouette) by d. During extended firing, heat having the recoil mechanism below die gun transmitted from gun tubes to tube. The design of the gun tube is not in- rails may cause warpage and fluenced to any great extent by the fixtures eventual binding. that hold it in the cradle. Since the gun tube e.

Misalignment may occur in dis- does not form the sliding surfaces for recoil, its continuous rails or slides causing contour, and hence wall thickness, need only them to bind during recoil and conform to the gas pressure distribution along counterrecoil. Binding of this na- its length. ture may prevent the gun tubes 13. There are several disadvantages as- from returning to the in-battery sociated with the U-type cradle. Some are position. discussed below. a. Fabrication is difficult. The B. THE 0-TYPE CRADLE structure is complex and a high 14. This type has a cylindrical tube for its degree of accuracy is required in basic structural element (Figure 4).

Each end machining the sliles and rails to contains suitable bearings in which the gun 3 tt*