US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com I -. - SLIDING SURFACES REISON TRUNNION RECOIL CYLINDER SECTION A-A (a) EXTERNAL RECOIL MECHANISM TYPE CRADLE - RECOIL CYLINDER COMBINATION-A SLIDING SURFACES __ __.k _. -- t rBREECH: GUNTUB TRION REC OIL PISTO N A TR UN NIO SECTION A-A (b) CONCENTRIC RECOIL MECHANISM TYPE Figure 4. 0-Type Cradles tube slides. The outside surface of the tube is 16. There are several disadvantages inherent cylindrical for a considerable length forward of to the 0-type cradle. The sliding surface of the breech. This surface is machined'smooth the gun tube is exposed to the weather, al-.

and the tube itself serves as its own slide, the though this can be eliminated by the installa- .. " bearings functioning as guides during recoil and tion of a shield. It dictates, to some extent, the counterrecoil. A key transmits the rifling diameter of the tube forward of the chamber torque to the cradle to prevent rotation of the because it cannot be tapered along the sliding tube. Brackets or some similar structure are surface. If the forward portion of the sliding j provided on the cylindrical portion of the surface is made smaller in diameter, then two cradle to attach the recoil mechanism, the sleeve bearings of different diameters are trunnions, and the elevating arc. necessary.

The effects of heating the gun tube 15. The use of an 0-type cradle offers sev- can be serious if the expansion exceeds the eral advantages. It is convenient to locate the clearances in the bearings. The clearances trunnions on the line of action of the recoiling which must be provided to avoid binding may parts to relieve the elevating gear of firing result in sloppy fits while the gun is cold. An- loads. The structure is comparatively light other clearance problem stems from the trans- which helps to increase mobility.

Use of the port condition, where road clearances may be 0-type cradle does not require the sliding critical with the recoil mechanism attached to surfaces to be attached to the gun tube, thus the top of the gun tube. eliminating this fabrication problem. The cylindrical surfaces reduce machining prob- C. OTHER 0-TYPE CRADLES lems and provide more accurate alignment. A- choice of a favorable location is available for 17. Another form of 0-type cradle is the con- the recoil mechanism. When the recoil mech- centric recoil mechanism type (see Figure 4b).

anism is on the tot, of the tube, it does not pre- In outward appearance, it resembles the con- S sent clearance problems while the tipping ventional type but, unlike the conventional parts are being elevated, type, the cradle' form the outer recoil cylinder 4, II GI