US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com R~IRAIL LL SBOTTOM OF SLIDE TT1 L L R' 2 (a) CONTINUOUS -RAIL ."LL FTOP OF SLIDE i-- RAIL RAI L 1'_BOTTOM -OF SLI DE _T - TTT L, IS THE DISTA'NCE TO THE CENTROID OF THE DISTRIBUTED ,L LOAD L IR2 (b) DISCONTINUOUS RAIL Figure 2. Load Distribution on Rails, UType Cradle 12_ _ _ _ weight are added algebraically as uniformly vere wear on the sliding surfaces, requiring distributed loads. early replacement. This condition must be 28. The maximum bearing pressure is then tolerated if no other design resource is avail- determined from the completed loadl diagram.

able but it usually means added maintenance A bearing pressure of 200 to 300 lb/in' is and should be avoided if at all possible. recommended for continuous motion but since, motion is not continuous, .bearing pressures 2.Cntuio as high as 500 lb/in, are permissible. If pres-2.ontuin suresexceed this limit, there is danger of se- 29. The sliding structure which supports