US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com -k the recoiling parts consists of male and female support the rails against either upward or members. The male members are called rails downward loads. Bronze liners with surface or slides and the female members are called finishes between 32 and 63 microinch rms guides. These latter are similar to channels cover the rai!s and slides to provide the bearing in cross section, so that bearing surfaces will surface (Figure 13). The guides are unlined but their surfaces are machined to the same -SLEIGH finish as the rails and slides. -SLIG 30. Rails are usually secured to the tube.

GUIDE The front attachment is to a sleeve or flat GUIDE-'--' / ring, either clamped or shrunk on the tube. The rear attachment is to a similar ring or it may be the breech ring. Figure 14 shows a typical installation. The rails or guides may LINER- / be continuous or discontinuous. If the guides ?CRAD~.E are discontinuous, they are sometimes called clips. Discontinuity in the sliding surfaces is not recofnmended if contact between them is broke-i during the recoil stroke because of the difficulty in re-entering the guides during S counterrecoil. The present trend in design is to have continuous rails on the gun tube. 31.

When a sleigh is used, the gun tube is held securely to it by collars or yokes as shown Figure 13. End View of Sliding Structure Showing in Figure 15. Figure 16 shows another type Bearing Liner sleigh. This one has the recoil cylinders Figure 14. Tube Assembly Showing Rails CENTER YOKE FRONT YOKE _i i RECUPERATOR -- ~GU -- 1 -:- -- SI t - RECO:L CYLINDER Figure 15. Sleigh With Attached Recoil Cylinders, Gun Tube Secured With Yokes 13