Downloaded from https://www.everyspec.com LOCKING WEDGES ' ( ) IN LOCKING POSITION WEDGE SCREWS Pl B t SLIDE _ GUIDE cUIO -RECUPRERATOR % , (a) LOADING DIAGRAM PCCOIL /WEDGE CYLINDERS LOCKING SOLT Figure 16. Sleigh With Integral Recoil Cylinders integral with the sleigh body. Close fitting mating lugs on tube and sleigh preclude tipping while locking wedges preclude relative longi- tudinal motion. The wedges move laterally and fit into recesses machined in the tube structure. The structure forming the sliding ( surfaces may be bolted or welded to the sleigh. (b) CANTILEVER BEAM ANALOGY Sometimes they form an integral part, being Figure 17.
Slide and Guide Showing machined from the sleigh or cradle structure. Assumed Defections 32. The strength of the rail, slide, or guide is determined by the following conservativ-2 contact area, thereby intensifying the pressure. method of analysis. Assume that the maxi- Two types of deflection may occur, One in- mum distributed load is constant for a distance volves bending of the vertical members which of one inch. Isolate a one-inch length of causes the contacting areas to rotate and thus structure with this load and investigate its overload the edges of the bearing. This is il- strength.
Thus at Section A-A of Figure 17a, lustrated by the phantom member in Figure which is one inch deep, 17a. However, if both members are identically w = lb/in, unit load, maximum intensity constructed, angular deflections will be equal F = 1 X w, lb, total load and the whole contact area remains intact. M = Fd, lb-in, bending moment The other deflection concerns the equivalent A = 1 X a, in 2 , area of section in tension cantilever beam of the bearing members as illustrated by the sectional view in Figure 17b.
= c+ -, lb/in 2 , tensile stress in section This deflection poses a difficult problem for, I as the beam deflects, the load immediately (I1) becomes redistributed over a smaller space 33. In addition to strength requirements, with accompanying higher pressures. Since the sliding members must have ample contact- the mating parts are of similar construction, ing surfaces to insure a reasonable bearing they deflect similarly with the result that the pressure (Paragraph 28). But large areas contact area becomes progressively smaller, alone may not achieve a reasonable pressure theoretically approaching a line.
Actually, if ensuing deflections cause a reduction in line contact never material'zes but pressure 14