US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com - 3.5 X 10-' in/in/F larger than that for ated. respect to these lines of action determines the j / This value is computed from the coefficients in womeait. Thus, from Figure 18, the centigrade scale of 16.8 X 10 - 1 for phos- phor bronze and 10.5 X 10 - 1 for 1.2% carbon MT bF, - aF, (12) steel.* Based on an ambient temperature of where a, b = moment arms 70"F, the extreme ranges will show a difference F. F, -K, inertia force at CG in dimensions for bronze and steel of 0.00033 F, = propellant gas force in/in at 165°F and of -0.00047 in/in at K = recoil force -65 0 F.

The lower limit of the temperature Mr = trunnion moment extremes because of climatic conditions hA the If F and F represent the maximum inertia greater effect. However, neither extreme re- and propellant gas forces respectivery, the hquires excessively loose fits to compensate for ideal trunnion location lies within the limits of the thermal activity b _Z a 4 (F/F,)b although it is not always feasible to have this arrangement. If a ex- F. LOCATION AND DESIGN OF TRUNNIONS tends beyond these limits, or if a and b lie on 38.

The location of the trunnions in the opposite sides of the tnmnion, then the mo- vertical plane directly influences the reaction ment will increase, varying as the distances. on the elevating gear during the recoil cycle. When a (F/F)b, the moment becomes zero In single recoil systems, the reaction is due when the gas ore becomes maximum. It solely to the moment about the trunnions pro- gradually increases as the gas force diminishes duced by the propellant gas force and the in- and reaches the maximum of ertia force of the recoiling peats. Figure 18 MT = -aF. = -aK (12a) shows these forces and the perpendicular Ma distance from their lines of action to the when the gas force becomes zero.

trunnions. The position of the trunnions with 39. In double recoil systems, the inertia force of the tipping parts caused by the accel- eration of the secondary recoiling parts be- comes a factor when determining the trunnion moment and, subsequently, the elevating gear reaction (see Figure 9).t The trurnion loca- tion with respect to the center of the bore has little influence with this additional moment be- R cause the component of force perpendicular to the bore center line has a moment arm consid- erably larger than that for the parallel com- ponent. K40.

The trunnion loads are composed of five components which are derived from the weight of tipping parts, recoil force, equilibrator force, force due to the rifling torque, and elevating gear reaction. The first four do not vary with FcL = INERTIA FORCE OF RECOILING PARTS trunnion location but form the bulk of the maximum trunnion loads; consequently, any Fg = PROPELLANT GAS FORCE change in the elevating gear reaction will not K - RECOIL FORCE materially affect the trunnions but small MT = MOMENT ABOUT TRUNNIONS shifts in trunnion location may greatly in- fluence elevating gear reactions. Figure 18. Trunnion Location With Respect to Recoil 41.

Sometimes the location of the trunnion Forces in the vertical plane is adjusted to satisfy * Reference 5, page 2239. t Reference 2, Chapter XI. I ~16 _)